Spyke

Posts

3dprinting·3DPrintingbyThePantser

Tired of expensive disposable batteries and rechargeable AA suck. So I made a 10k mAh pack for my deadbolt.

Eneloops would only last about 3 weeks. And disposable last 2 months. This door is used a lot and since it has Zwave and a door open sensor it sends info on every open.

Bonus, since it can handle the lipo AA batteries that put out 1.8v and it gives the motor more oomph I made the battery pack give 7.2v and it never sticks anymore.

This is a garage-door so its not critical access but is used a lot.

View original on sh.itjust.works
364
3dprinting·3DPrintingbyThePantser

In case of 86-47

I'm too old school for a multi color printer so this has some defects. I printed .02 layer then do a color change so in a way it smashes it all together and since its such thin layer its hard to see around the edges. The plexi sheet is actually imbedded into the print, I left a gap in the model and paused the print and inserted the plexi, it then printed over the edges.

As for the tubes they are place holders until we get something better.

View original on sh.itjust.works
139

You reached the end