Using baking soda a bit of water and some time will also get rid of the corrosion along with neutralizing the acid which tends to come back otherwise.
Just disconnect and remove the battery. Wipe the battery with a paper towel covered in a paste made from baking soda. After, rinse it off with some clean water. Clean and rinse the car's battery tray and Clamp like you did with the battery. Get a large-ish bowl or dish with some water and. Soak the harness terminals for a few minutes while adding baking soda until it stops fizzing. Get an old toothbrush and scrub the terminal with a baking soda paste. Rinse, re-install everything and you're done.
It got my harness terminals from a crystallized mess from leaking to looking brand new (seriously) and none an issue for the past 4 years.
35 replies
Pop the protective cap off the other end to reveal the combination butt plug side.
.
Pretty sure that's the optional sounding attachment.
GET IN THE ZONE
ER-ZONE
A battery terminal is like half an inch across.. op has unlocked self burn
It's not designed to accommodate size ... it's meant to cut everyone down to size
Hey honey wake up, new circumcision just dropped
Uh, no thanks we've all already got one
No no, this is the new updated circumcision!
Never too late
https://exclaim.ca/film/article/we_talked_to_the_how_to_with_john_wilson_foreskin_guy_about_parasite_the_magnetic_fields_and_tim_robinsons_tc_tugger
If everyone is small... no one will be. Life will finally be fair.
Yeah I wouldn't even touch the sides.
That's for batteries?
Using baking soda a bit of water and some time will also get rid of the corrosion along with neutralizing the acid which tends to come back otherwise.
Just disconnect and remove the battery. Wipe the battery with a paper towel covered in a paste made from baking soda. After, rinse it off with some clean water. Clean and rinse the car's battery tray and Clamp like you did with the battery. Get a large-ish bowl or dish with some water and. Soak the harness terminals for a few minutes while adding baking soda until it stops fizzing. Get an old toothbrush and scrub the terminal with a baking soda paste. Rinse, re-install everything and you're done.
It got my harness terminals from a crystallized mess from leaking to looking brand new (seriously) and none an issue for the past 4 years.
They probably are. I think I may need a new one. Or I should at least try disconnecting and reconnecting.
Yes, car batteries. Meant to clean corroded terminal posts.
Oh! Cool, thank you. I really should more about car batteries. I'm unsure about mine.
Don't worry, they're fine.
I'm not sure...
If you lick the terminals and it tastes like sour lemon that means it's working.
brb
Well duh. Why would you buy it when you can just use it in the store and leave it back on the shelf after you're done?
Not sure if you're a pragmatist or a cheap bastard *squints*
My resume/rap sheet lists neither of those labels explicitly, but I'm sure it's a little of both.
SHAI HALUD
Cyborg sandworm
But how else are you supposed to remove the warts and barnacles?
With sandpaper, by hand, if you're at all serious about your craft.
Industrial plies & an electric sander, with a bit of motor oil to keep your skin moist and smelling great
Damn, that explains the incident with the sand blaster!
Plus it’s way too big
Hah! Joke's on you. Unless I'm rubbing it against the sides I don't think I'd ever feel it. #smolppgang
Skill issue
Its not terrible if you use it with Valvalene brand oil based lubricant.
Depending on.... your preferences.