Spyke

Replies

dach

Comment on

Ministerpräsident Schulze für Gegenleistungen bei Bürgergeld

Was für ein Blödsinn. Ich zahle doch genau dafür schon Steuern, dass das Sozialsystem mich auffängt, wenn ich keine Arbeit finde bzw. nicht arbeiten kann. Das ist doch meine Gegenleistung fürs Arbeitslosengeld, in welcher Form auch immer. Das ist der Grundsatz vom Land in dem ich lebe, das wir für einander aufkommen und einstehen. Wenn er Leute braucht, die für öffentliche Gelder Schnee schippen, kann er einfach eine öffentliche Stelle ausschreiben - das wäre sogar ein WinWin auf dem Arbeitsmarkt, idealerweise findet damit jemand einen Job aus der Arbeitslosigkeit und ist damit auch aus der Statistik raus. Da muss kein neues Werkzeug her, wir haben genau das was er will schon, nur eben mit weniger denunzierenden Formulierungen.

Comment on

Microsoft Teams status

Reply in thread

Bonus: share a 24h fireplace video to your meeting, now you’re listed as ‚presenting‘ and do not disturb activates. The 24h fireplace video will keep your device from going to standby/sleep. My trick to get actual work done.

dach

Comment on

Empfehlungen für Kochbücher o.Ä. mit einfachen Rezepten?

Ottolenghi hat echt gute Kochbücher, guter Einstieg ist wahrscheinlich das Simple oder Flavor. Ansonsten ist Salz, Fett, Hitze Säure ein richtig gutes Nachschlagwerk für das Konzept hinter Geschmack, auch einfach eine sehr gute und theoretische Herangehensweise ans Kochen. Persönlich stehe ich auf die Kochbücher von Molly Baz, sowohl Design als auch Gerichte sind hervorragend. Im Veganuary dieses Jahr habe ich mir Zizi: Taste of Love gekauft und einiges daraus gekocht. Alles gute Bücher, anfangen würde ich mit Salz Fett Hitze Säure, das legt das Fundament für jedes Gericht.

Comment on

Trouble keeping a top-heavy TPE part on the bed

If you have a PEI sheet, try glue stick on the PEI sheet to print. The glue stick acts as a leveraging agent after printing, you can wash it off with warm water - otherwise the flexibles tend to stick too good and ruin the built plate. I use this method on my prusa mini for TPU where I had similar issues. Sticking flexible filament on the textured sheet can be hard, I had success by printing the brim layer in PLA in the past - but that was still on a Makerbot Mk2 which didn’t even have a heated bed.

You reached the end