You could try using a thin sharp object, like a sewing needle, and heating it up with a lighter, and then stabbing it into the broken off pieces. Once it's had a few minutes to cool off, hopefully the melted plastic sticks to the needle and you can pull it out.
To improve this method, stick the needle in at an angle, and then lift straight up and out (not along the angle of insertion, or lever it out. This way you can get it to come out even if it is poorly or not adhered to the needle.
To my mind, that could work, the barb might not be helpful since the material might not flow quite as readily back over it as soft tissue does, but you could get an angled insertion and pretty easily get direct upwards lift with it maybe.
You might be able to fit a fish hook in down the side between the broken stem and the switch, and use the barb to pull out the stem.
That seems risky! It's so small, unless you have an extremely steady hand (and preferably experience) it would be really easy to accidentally get glue on the sides or top
Is it a hot swappable switch?
If it is, pop it out and take it apart, you'll need to push the stems from the holes but once it's apart it's fairly trivial to do.
If it is not hot swappable you can probably pry it apart but it will be considerably harder.
You could try using a thin sharp object, like a sewing needle, and heating it up with a lighter, and then stabbing it into the broken off pieces. Once it's had a few minutes to cool off, hopefully the melted plastic sticks to the needle and you can pull it out.
That worked. Good idea!
To improve this method, stick the needle in at an angle, and then lift straight up and out (not along the angle of insertion, or lever it out. This way you can get it to come out even if it is poorly or not adhered to the needle.
Additionally, if it's a needle you don't care about, give it a pass with sandpaper. Rougher texture will make it adhere better.
Fishing hook?
To my mind, that could work, the barb might not be helpful since the material might not flow quite as readily back over it as soft tissue does, but you could get an angled insertion and pretty easily get direct upwards lift with it maybe.
You might be able to fit a fish hook in down the side between the broken stem and the switch, and use the barb to pull out the stem.
I was thinking about dipping a toothpick in super glue and touching the stem after spraying some activator on the stem, but your style sounds better.
That seems risky! It's so small, unless you have an extremely steady hand (and preferably experience) it would be really easy to accidentally get glue on the sides or top
In a similar situation, I managed to extract the broken bit with a needle and some perseverance. I did not have to heat the needle.
Is it a hot swappable switch? If it is, pop it out and take it apart, you'll need to push the stems from the holes but once it's apart it's fairly trivial to do. If it is not hot swappable you can probably pry it apart but it will be considerably harder.
Are those sunsets? I've got a few spares if you can't fix this one.
Thats genuinely a really sweet thing to offer someone
I just love keyboards and anyone else who does too!
Thats a really lovely sentiment; folks like you are what makes communities special :)
You're too kind. I got it working again - thanks for the offer!
♥️
If you’ve got one, a tiny drill bit and pin vice would likely work.