I made a gear thing
Here is it spinning
Edit: I realized streamable is going to delete the clip after 48 hours so here's a YT short https://m.youtube.com/shorts/HrR38A1gqhU
157
Comments26View original on lemmy.world
Here is it spinning
Edit: I realized streamable is going to delete the clip after 48 hours so here's a YT short https://m.youtube.com/shorts/HrR38A1gqhU
"hop in, we're torquing"
"I've been shaking my ass for hours but nobody joined in. Turns out I misheard you"
I sure hope that last gear does not have anywhere to be any time soon.
Something something… heat death of the universe.
Don't stop cranking it before you achieved a full turn on the last gear, or the world will come to an end! You started it, you have to finish it!
Now we're torquing
Now put the cordless drill on it
I did.
The plastic on the crank spindle started melting lol
Dang. I did not say go full blast ;) do you have that video too ???
Imagine the speed if you had driven the red-dotted wheel ......
It could be turned by hand up to the gear with the green dot, then it became physically impossible by hand. I didn't dare try hooking up the drill because I thought the plastic gears would just explode
Already by the green dot gear, one turn of that was spinning the 1st gear about 500-1000 times
Yeah, probably would explode. Only way might be to set it in motion from the green one and take it overt on the red one once the cogs picked up some speed. But most probably they will melt before that, the speed will be much to high.
But fun, thnx for sharing!
now reverse it
Is this the worlds weirdest excercise equipment or some other purpose or a 'hey look what I can make' thing
It's an idea I came up with when I was 24 years old, so that's 27 years ago. I finally managed to salvage enough gears to make it happen.
I'm sure I'm not the only person to come up with this, it's not a particularly clever thing it's just neat to me.
An extra idea: grab solar panel. Grab motor. Attach to bottom gear. Attach a big stick to last motor. See how long it takes for big arm to go all the way around
This is one of 8 computer pads that I use as crafting mats to protect my counter. I got them at Goodwill for $1
Only real ones know her name
John Fate.
"What does it do?"
"Gears"
What's the ratio on this bad boy?
Looking at the diameters of the gears and eyeballing it, approximately 10,000:1
I'm actually not 100% sure because I made it all with salvage gears that I've gathered from years of electronics repair. A couple of them I had to glue two together to get the reduction.
I think there are four that are 11:44 (1:4) and four that are 22:44 (1:2)
4x4x4x4x2x2x2 = 4096 turns of the first wheel to make the final wheel turn once.
Again this is an approximation because it's all salvage, and I didn't really count teeth except a few times. Also I later attached to the handle and the offset gear there, and there's a teeth mismatch so I think that's like 62:50 or something oddball... I'm not counting that.
Screw the math. Count it.
Cool!