cross-posted from: https://lemmy.world/post/2026026

The box is not printed as a single piece, but 6 modular plates joined with dovetail joints. Individual plates are relatively flimsy, but once assembled the box is rock solid.

This way, it is much faster to print, and is stronger since the layer lines are protected. It also let me experiment with infill for some cool effects.

Closer look at the top pattern

Front pattern

You can't see from the images, but each plate is printed without top layers, which make it even faster to print and use even less filament, compared to a vertical wall of the same weight.

The back

Gyroid air vent

The box is not printed as a single piece, but 6 modular plates joined with dovetail joints. Individual plates are relatively flimsy, but once assembled the box is rock solid.

This way, it is much faster to print, and is stronger since the layer lines are protected. It also let me experiment with infill for some cool effects.

Closer look at the top pattern

Front pattern

You can't see from the images, but each plate is printed without top layers, which make it even faster to print and use even less filament, compared to a vertical wall of the same weight.

The back

Gyroid air vent

I have a bltouch clone which work fine on glass bed. After switching to textured PEI sheet, it's variance trippled to 0.1mm, which make my bed mesh all wobbly.

I'm I suppose to remove the steel plate when making the bed mesh? Do you home Z with a probe with this setup?

The weirdest thing is, despite all this all my prints adhere completely fine. I guess PEI is just that good.