Spyke

Replies

Comment on

My resin setup

Reply in thread

I have wondered about it myself, but it hasn’t caused any problems in the 6 months I’ve been printing. The curing station cover is supposed to block 99.95% of UV rays according to Elegoo’s website.

dnd

Comment on

DMs, have you ever given your party a victory lap against the BBEG? How did it play out?

Reply in thread

Basically this. The party has finished the actual final fight, but you throw something at them and give them some kind of boost that’ll let them go ham. Kind of a form of catharsis, letting them feel like bad-asses. Kinda like FFVII or Demon Souls.

I’m thinking about giving my players a victory lap, where they’ve already beat the BBEG in two or three phases, then have to escape the castle as it crashes down around them. From the rubble comes the BBEG, transformed into a gargantuan monster by his dark god. However, by slaying him and doing a bunch of other stuff, the PCs have finally returned the good diety to the land. He gives them a blessing that’s basically a long rest + massive damage buff. Queue the heavy metal soundtrack while I narrate my players being complete badasses while they fight this massive beast.

dnd

Comment on

Are 6 players too many??

I'm currently running with six. It is manageable and still fun, but I would not add another. 4-6 seems to be the sweet spot.

With six, you do have to make an effort to ensure that everyone is being included. To speed combat up, I make sure to let the next player know when their turn is coming up next so they can prepare.

Comment on

Built my first PC! Thanks so much for the advice.

Reply in thread

The hardest part for me honestly was trying to figure out how to get the heat sink back on the m2 after I installed the ssd lol. Took me an hour before I realized there was an extra screw.

Also took me another hour trying to figure out how to install the motherboard in the case. I finally realized that the case had some standoffs in a baggie tucked away in the psu compartment.

I should have taken the advice I read not to start at 9 PM lol.

Comment on

My resin setup

Reply in thread

99% alcohol. It’s probably the main reason for the vent and wearing a mask, since the resin fumes themselves don’t spread very far depending on how long I have the lid off.