Copyright infringement is not theft, and it is not immoral. It has never been, and it will not start to be, just because a company we don't like is doing it.

*You stay in Wayland.

False. The remote in the picture uses AAA batteries, and the controller takes bigger AA.

It's a joke, because the standard is 8601, not 6801.

All the motors were ok. I think i had yaw pid too low. Unfortunately the blackbox didn't work.

This is my current build:

• Speedy Bee F7 V3 stack
• T-Motor VELOX VELOCE V2207.5 V2, 2550KV motors
• FrSky Archer RS receiver
• DAL T5047C propellers
• Kavan 4S battery

With this frame you should use a stack or all in one. Four single motor ESCs would be impractical. When searching for a controller you may want to check if it is supported by inav or ardupilot to keep your options open. All boards are supported by betaflight, but it's not very beginner friendly.

Hardware is easy, you would need a tx module. Perhaps something like this:

https://www.tinywhoop.com/products/happymodel-es24tx-pro-elrs-2-4ghz-rc-transmitter-module

The module needs 5V and has an UART interface. Also note the tx module is a transmitter, but also a receiver - It receives telemetry data like drone position, altitude.

I don't know if there is a software for PC available that can control the drone directly, like in a game. Check this page for software that is used to plan gps waypoints for drones:

https://ardupilot.org/copter/docs/common-choosing-a-ground-station.html

I have made this. It may be a little what you are looking for, but it is definitely not well documented. Gopro holder is not yet in repo, i am going to add it.

It helped me to turn up the volume on center speaker directly on the speakers. Using the speakers infrared remote control. It goes -4 to 4 for all speakers and on +4 i can usually understand what are the actors saying.

I'm sorry, are you from the past?