Well this stinks
Worst part, this is the one component Prusa injection molded with no parts 3D Printable. I'll probably figure something out.
View original on programming.dev
Worst part, this is the one component Prusa injection molded with no parts 3D Printable. I'll probably figure something out.
Just print a ne- Oh... Yeah.
Seriously tho: Can't engineer your own? How complicated is the broken plastic part?
There are some community prints like this. https://www.printables.com/model/194982-prusa-minimini-no-logo-frontrear-plate-with-honeyc
But I don't know how brave I feel about taking it apart again.
Send them a message? They are usually very helpful, you might be able to either get a model or a replacement part.
is it Abs? if so you could try welding it with acetone.
Just tried it, worked to hold it in position for a bit. Fell apart once I started to use it mechanically.
Superglue?
The plastic is brittle. I think I'll just delay the inevitable if I use super glue
Contact them