j3dprintingยท3DPrintingbyjtablerdย lots could be done to dial it in but protopasta iron fill pla is a super cool material to play withView original on lemmy.world83Comments8Reply
jjtablerdย replylemmy.worldSo if I put a 10x40mm neodymium magnet on my fridge it'll hang horizontally from that, but it won't stick to fridge by itself5Reply
Flaky_Fish69ย replykbin.socialLooks a bit more like salt+vinegar (in water to control the speed)4Reply
CCiaocibaiย lemmy.world1Hide 1 replyNo clogging issues or anything? The after result looks mint.3Reply
jjtablerdย replylemmy.worldRemarkably, no - I did crank flow to 110 because I was worried but went fine through regular .4 (hardened steel) nozzle I also have a roll of their cf htpla that I haven't touched because I'm scared of clogging with cf but will be giving it a shot soon5Reply
8 replies
How magnetic is it?
So if I put a 10x40mm neodymium magnet on my fridge it'll hang horizontally from that, but it won't stick to fridge by itself
Oh wow! How did you treat it after printing? Water soak?
Looks a bit more like salt+vinegar (in water to control the speed)
No clogging issues or anything? The after result looks mint.
Remarkably, no - I did crank flow to 110 because I was worried but went fine through regular .4 (hardened steel) nozzle
I also have a roll of their cf htpla that I haven't touched because I'm scared of clogging with cf but will be giving it a shot soon
Wow, that does look great! Didn't know about that filament
Looks great ๐