cross-posted from: https://lemmy.world/post/14180956

Hello all you lovely people!

I'm trying to figure out if I can port forward to different servers based on the destination domain.

I have a domain with a wildcard cert and I'd like to be able to route all traffic headed towards "1.domain.com" to a server I'm calling "1". I'd still like traffic headed to domain.com to go to where it's currently going, we can call this server "0", and to be able to have a 2.domain.com or 3 or 4 in the future.

I thought that having a port forward rule with: interface: WAN Protocol: any source: any destination: a url alias including 1.domain.com redirect target ip: local ip

Would work, but it doesn't seem to. Any tips?

Hello all you lovely people!

I'm trying to figure out if I can port forward to different servers based on the destination domain.

I have a domain with a wildcard cert and I'd like to be able to route all traffic headed towards "1.domain.com" to a server I'm calling "1". I'd still like traffic headed to domain.com to go to where it's currently going, we can call this server "0", and to be able to have a 2.domain.com or 3 or 4 in the future.

I thought that having a port forward rule with: interface: WAN Protocol: any source: any destination: a url alias including 1.domain.com redirect target ip: local ip

Would work, but it doesn't seem to. Any tips?

Hi all, I've got a cheap Celeron box running OPNSense and it's been pretty good so far, but I found twice that the device turned off at some point while I was at work, and I have been unable to figure out what's causing it.

The only change was that I enabled Monit to see if I could figure out what was causing crowdsec to stop sometimes but never ended up configuring anything. I've only been running it for a couple months though, so it's possible that that is not related.

I know that on a Mac (based on freebsd, right?) you can determine whether the shutdown reason was a hard shutdown, regular shutdown, or the power cable being unplugged. Is it possible to do that with OPNSense? I'd like to narrow it down to software or hardware ideally.

Hi all, I've got a cheap Celeron box running OPNSense and it's been pretty good so far, but I found twice that the device turned off at some point while I was at work, and I have been unable to figure out what's causing it.

The only change was that I enabled Monit to see if I could figure out what was causing crowdsec to stop sometimes but never ended up configuring anything. I've only been running it for a couple months though, so it's possible that that is not related.

I know that on a Mac (based on freebsd, right?) you can determine whether the shutdown reason was a hard shutdown, regular shutdown, or the power cable being unplugged. Is it possible to do that with OPNSense? I'd like to narrow it down to software or hardware ideally.