When you let the smoke out of your very last Arduino Nano.
I give you Frankenduino. It's an Arduino ProMini soldered onto a piece of protoboard and wired up to the Nano pinout.
I have 10 Nanos on order but I really needed to keep the project moving.
This ProMini has an ATMEGAS168 chip on it but that's good enough for what I'm doing.
4 replies
Why is this wire damaged? Too many drinks when soldering or not enough?
I forgot a couple of wires and had to add them after the fact. I got a bit close to that one with my soldering iron. The insulation is melted right down to the wire but it's outboard and only used for development so I hope Lemmy QA will give me a pass.
the “any landing you walk away from is a good landing” defense?
Yup. That's my story and I'm sticking to it.